Cleaning; Cleaning The Dryer And The Control Panel; Cleaning The Moisture Sensor; Cleaning The Filter In The Condensate Container - Siemens WT47W540BY Installation And Operating Instructions Manual

Cleaning

en
D
Cleaning
C leaning the dryer and the
C l e a n i n g
control panel
:
Warning
Risk of death!
There is a risk of electric shock as the
dryer is operated with electricity.
Disconnect the dryer from the mains
before cleaning.
Clean the dryer using only water and a
soft, damp cloth.
Remove all detergent residue, spray
residue or other residues immediately.
Do not use cleaning agents or agents
for pre-treating laundry (e.g. prewash
sprays, stain removers). Do not use
high-pressure cleaners or steam jet
cleaners to clean your appliance.

Cleaning the moisture sensor

The dryer is equipped with a
Note:
stainless-steel moisture sensor. The
moisture sensor measures how damp
the laundry is.
After long periods of usage the moisture
sensor may become covered by a fine
layer of limescale or residues of
detergents and care products. Such
residues must be removed regularly as
the sensor function and in consequence
the drying result may be impaired.
Open the door and clean the moisture
sensor with a coarse sponge.
Caution!
Moisture sensor may be damaged.
Do not clean moisture sensors with
abrasives and steel wool.
32
Cleaning the filter
in the condensate container
The filter in the condensate
Note:
container cleans the condensation
water that is used during the dryer's
automatic cleaning cycle.
Pull out the condensate container
1.
horizontally.
Pour out the condensation water.
2.
Remove the filter.
3.
Clean the filter under warm, running
4.
water or in the dishwasher.
Push in the filter until you feel it lock
5.
into place.
Caution!
The dryer may be contaminated
with fluff and thus become
damaged.
Only operate the dryer with the filter
inserted.
Push in the condensate container
6.
until you feel it lock into place.