Changing The Condensation Drain - Siemens WT47W540BY Installation And Operating Instructions Manual

Installation and connection
en
During installation ensure that:
The dryer is placed on a clean, level
■
and firm surface,
The mains plug can be accessed at
■
all times,
The air inlet on the dryer is kept clear
■
and there is sufficient ventilation,
The area around the dryer is kept
■
clean and
The dryer is levelled using the
■
threaded feet.
Check the alignment of the
Note:
appliance with a spirit level and
correct if necessary. Change the
height by turning the appliance feet.
All appliance feet must stand firmly
on the ground.
Incorrect alignment may cause high
noise levels, vibrations and improper
movement of the drum.
If in doubt, have the appliance
Note:
connected by a specialist.
Changing the condensation
drain
Notes
The condensation from the dryer can
■
either be discharged into
the condensate container or drained
off via a connection to the waste-
water system. The factory setting is
for the condensation from the dryer
to be discharged into
the condensate container.
If the condensation drain is installed,
■
residual water remains in
the condensate container because
of the dryer's self-cleaning function.
14
Change the condensation drain as
follows:
Remove the accessory from
1.
the dryer drum.
Delivery status of the dryer. The hose
2.
for discharging the condensation
into the condensate container is
secured to the connecting piece.
Disconnect the hose from
3.
the connecting piece and move it
into the "parked" position.
Remove the drain hose from
4.
the accessory and secure it to the
empty connecting piece.