Table of Contents
Advertisement
Available languages
Available languages
To activate the simulation mode:
page « SIM » is displayed, then press
to switch "OFF".
seconds.
2.4.6. Key beeps
The key beeps can be activated or deactivated.
To activate or deactivate the key beeps:
"bIP" is displayed, then press
switch "OFF".
Press
to exit setup mode, or automatic timeout after 10
seconds.
2.4.7. Resetting data in the memory
At any time, the memory of the display can be returned to factory settings. To do
so, a memory reset command is accessible in the menu.
The following parameters are restored in the memory:
Anemometer unit:
Wind indicator and anemometer filtering:
Wind calibration coefficient:
Gauge calibration coefficient:
Wind and battery alarms:
Wind indicator angle (180/360):
Backlighting level:
To reset the memory:
page "RSt" is displayed, then press
the reset.
Press
to exit setup mode, or automatic timeout after 10
seconds.
to switch "ON" and
until the simulation
to switch "ON" and
until the beep page
Knots
slope at 1
deactivated, threshold at 0
0/180° port, starboard
deactivated
0 (OFF)
until the reset
or
to activate
to
13
Hide quick links:
Advertisement
Chapters
Table of Contents
