Selecting The Pointer; Simulation Mode; For 2 Seconds, Then Again On; Press - ADVANSEA WIND S400 User Manual

To calibrate the wind angle:
menu

Press

for 2 seconds, then again on

page "diR" is displayed, and adjust the value using the
Press to exit setup mode, or automatic timeout after 10 seconds.

2.4.4. Selecting the pointer

1 of the 4 available pointers can be selected to display the apparent wind angle in
analogue form.
To set the pointer:
Press for 2 seconds on
displayed, then adjust the required value using the
Press to exit setup mode, or automatic timeout after 10 seconds.

2.4.5. Simulation mode

Simulation mode is used to display coherent data which are simulated and not
measured by the sensors. When this mode is in operation, a
flashing at the bottom of the display.
In simulation mode, the following data are available:
An apparent wind speed and angle,
A true wind speed and angle,
the real supply voltage,
Transmission of simulated data via the NMEA output,
Transmission of simulated data via the communication bus.
menu
menu
, then on
Installation and Operation Manual S400 series
menu
until the wind indicator calibration
and
until the pointer setup page "Ptr" is
and
keys.
keys.
icon appears
12