Configuration; Filtering; Calibrating The Apparent Wind Speed (Slope); Calibrating The Apparent Wind Angle (Offset) - ADVANSEA WIND S400 User Manual

2.4. Configuration

2.4.1. Filtering

A filter coefficient is available to the user for the apparent speed and angle. This
coefficient acts simultaneously on the wind indicator's angle measurement and on
the anemometer speed. This parameter can be adjusted to between 1 and 30
seconds.
To adjust the filter:
Press for 2 seconds on
setup page is displayed, then adjust the required value using
the and keys.
Press to exit setup mode, or automatic timeout after 10
seconds.

2.4.2. Calibrating the apparent wind speed (slope)

The wind speed was calibrated accurately during manufacture of the unit. However,
if you believe it is wrong, you can recalibrate it.
To calibrate the apparent wind speed, replace the speed measured by the wind
vane-gauge sensor in the calibration menu, with the speed estimated by the user (in
parallel with another instrument, hand wind gauge, etc.).
It is not possible to enter a calibration value when the apparent wind speed is equal
to "0".
To calibrate the wind speed:
menu
Press

for 2 seconds, then again on

speed calibration page "SPd" is displayed, and adjust the value
using the and
Press to exit setup mode, or automatic timeout after 10
seconds.
2.4.3. Calibrating the apparent wind
angle (offset)
The apparent wind angle is calibrated by replacing the wind
angle measured by the sensor with the wind angle estimated by
the user.
menu menu
, then on
keys.
Installation and Operation Manual S400 series
until the "dAM" filter
menu
until the wind
11