Sensor Access X-PIN Install Manual page 3

X‐PIN & X‐PROX
Install Guide
SWITCHING OPERATONAL MODES
From Normal to Secure Mode / From Secure Mode to Normal
The default factory setting for the normal / secure code is 3838
1) Enter the normal / secure code
• Mode indicator will flash red (normal to Secure) or flash Green (Secure
to Normal)
2) Depress the # key to confirm the Mode change
• Mode indicator is red to confirm in Secure mode/ or green to confirm
Normal Mode
STANDARD METHOD FOR ENROLLING
1) Enter the programming mode.
2) Depress 7 to enter Menu 7.
•
The Door indicator will turn orange.
3) Enter the 3‐digit user slot number into the memory (from 001 to 500) so as to enroll
a primary or secondary code.
•
For example, the user slot 003 represents user no. 3.
4) At this time three possibilities exist:
a. If the selected slot has no primary code, the Mode indicator will flash green,
indicating that the controller is ready to accept a primary code.
b. If the selected slot already has a primary code, but no secondary code, the Mode
indicator will flash red, indicating that the controller is ready to accept a second‐
ary code.
c. If the selected slot already has a primary and secondary code, a long beep will be heard and the controller
will return to its normal mode.
5) Enter the code to be assigned as the primary or secondary code for this slot number. If the code that is en‐
tered is valid, the Mode indicator will cease flashing and the controller is ready for the next 3‐digit slot number
(step 3) or depress the # key to move to the next slot number (step 4). If you do not wish to continue enrolling
codes, depress the # key twice and the controller will return to its normal mode.
www.sensoraccess.co.uk