AIWA
J
D ISA SSEM BLY INSTRUCTIONS
Removing the Main Case
1)
Remove 11 screws on the rear lid shown by arrows <
-----
-r O §"©On -
—
Ö 1 -
© o ________ j —
- Q
2)
Remove 9 knobs.
S g 3 )
Open the cassette lid.
(It is not required to remove the cassette lid)
-° v = C j
-
-" □
©<= "
Installing the Main Case
1)
Check that the fibre apper of the REC/PB PC Board (pattern
die) is fixed properly.
Firm ly fix the fibre paper using two-sided tape, etc.
because it is likely to lift up when it is peeled off
once.
2)
Lower all the lever switches in the direction of the arrow.
5 0 3 )
Be sure to install in the order (1) — (3). Be careful: when
it is mounted incorrectly, it may damage the dial plate
and the display PC Boards, etc.
4)
Match the knobs while performing item 3) and tapping the
side.
3
CS-880H,HG,U,UC