HBD-DZ170/DZ171/DZ175/DZ310/DZ510/DZ610/DZ810
2-8.
MAIN BOARD
6 wire (flat type) (9 core) (CN472)
5 wire (flat type) (24 core) (CN1101)
7 wire (flat type) (17 core) (CN503)
(DZ170/DZ171/DZ175)
wire (flat type) (19 core) (CN504)
(DZ310/DZ510/DZ610/DZ810)
8 CN1501 (6P)
9 wire (flat type) (5 core)
(CN1502)
qk two screws
(+BV3 (3-CR))
1 wire (flat type) (13 core) (CN507)
(DZ170/DZ171/DZ175)
wire (flat type) (15 core) (CN506)
(DZ310/DZ510/DZ610/DZ810)
Arranging the USB wire
Tie up with LP501.
14
2 CN906 (11P)
USB wire
qg four screws
(+BV3 (3-CR))
qh heat sink
4 CN2101 (5P)
qj five screws
(+BV3 (3-CR))
ql MAIN board
3 CN904 (5P)
The USB wire should be located on the front side
from these capacitors.
Thread the USB wire through
the capacitors.
Dress the USB wire in this area
properly along the board.
MAIN board
EXCEPT US, CND, SP, EA
qd screw
(+BV3 (3-CR))
qf insulated plate
(PC-DSZ)
When the heat sink
has been removed,
apply oil compound
(G-747) to it.
0 two screws
(+BV3 (3-CR))
qa insulated plate
(PC-DSZ)
qs shield plate (PC-DSZ)
US, CND, SP, EA
USB wire