Cloning Procedures; Learning Configuration From A Master Tv - LG 32LY760H Setup Manual

Cloning typically refers to the process of using a Master TV Setup to configure a Target TV. This
section describes how to save (Learn) a Master TV Setup and then transfer (Teach) it to a Target
TV using a USB memory device / TLX file.
You can also create a TLX file using the FTG File Manager and then use the Teaching procedure
to transfer the TLX file to Target TVs. Refer to "Creating an FTG Configuration File" on pages 45 to
46, as necessary.

Learning Configuration from a Master TV

This section describes how to Learn configuration from a Master TV.
Before You Begin
• Ensure the USB device has been formatted with FAT format.
• If the TV is NOT already in FTG Mode, complete the Custom Master TV Setup procedure (see
pages 36 to 38).
• If you would like the Target TV(s) to remain in Pass-through Mode after Teaching, ensure the
Master TV does not have an auto-tuned/edited channel lineup; otherwise, Teaching the Learned
file will result in the Target TV(s) being configured for FTG Mode.
• If you intend to use the TV's Zoning feature(s), make sure to assign the appropriate TV Zone #
and/or Wi-Fi Zone # as described in Reference section, "Using the TV's Zoning Features,"
BEFORE performing the Learning procedure. Also, for Wi-Fi Zoning in particular, the TV's
wireless network connection settings should be configured in the IP Environment Menu before
Learning is initiated.
• It is not possible to clone a Master TV's clock. Either set a Target TV's clock manually, or use
the Auto Clock setting in the TV setup menus.
Caution: Do not unplug the TV power cord or remove the USB memory device while
Learning is in progress, as doing so may cause the TV to malfunction or harm the
USB device, respectively.
Learn Configuration from Master TV
1. Ensure the Master TV is set up completely and turned ON.
2. Insert the USB memory device into either of the USB ports on the Master TV.
3. Press MENU SETTINGS on the Installer Remote to display the TV setup menus (TV is in
Pass-through Mode) or the Function Menu (TV is already in FTG Mode).
4. Use the arrow navigation keys to select/highlight either the General menu icon from the TV
setup menus or the Safety menu icon from the Function Menu. Then, press the number "7" key
a total of seven times to display the TV Manager / USB Download Menu.
Note: The TV Manager / Diagnostics Menu is for service use only.
5. To gain access to the "Learn From TV" option in the TV Manager / USB Download Menu, key
in the following number sequence on the Installer Remote: 9-8-7-6.
6. Use the Up/Down arrow keys to select Learn From TV (TLX), and then press OK.
206-4259

Cloning Procedures

(Continued on next page)
39