Installation - Luxibel LX119 User Manual

Protect this device from shocks and abuse. Avoid brute force when operating the
device.

Familiarise yourself with the functions of the device before actually using it. Do not allow operation
by unqualified people. Any damage that may occur will most probably be due to unprofessional use
of the device.

All modifications of the device are forbidden for safety reasons. Damage caused by user modifications
to the device is not covered by the warranty.

Only use the device for its intended purpose. All other uses may lead to short circuits, burns,
electroshocks, lamp explosion, crash, etc. Using the device in an unauthorised way will void the
warranty.

Damage caused by disregard of certain guidelines in this manual is not covered by the warranty and
the dealer will not accept responsibility for any ensuing defects or problems.

Mechanical wear and LEDs are not covered by warranty.

A qualified technician should install and service this device.

Do not switch the device on immediately after it has been exposed to changes in temperature.
Protect the device against damage by leaving it switched off until it has reached room temperature.

This device is designed for professional use on stage, in discos, theatres, etc. The device should only
be used indoors with an alternating current of 240 VAC, 50 Hz.

Lighting effects are not designed for permanent operation: regular operation breaks will prolong their
lives.

Use the original packaging if the device is to be transported.

Keep this manual for future reference.
4. Features

DMX control via 3, 4, 6, 8 or 12 channels for simple or advanced controlling
3 channel mode: HSV (hue, saturation, value) or HSI (hue, saturation, intensity)
o
6 channel mode: RGBWAP
o
8 channel mode: dimmer, RGBWAP, shutter
o
12 channel mode: dimmer, RGBWAP, shutter, macro, auto, auto speed, dimmer curve
o

built-in programmes with speed adjustment

static colour selection, with white colour temperature pre-setting from 3200 to 10000 K

master/slave mode for synchronized operation of multiple units linked in a chain

flicker-free operation (400 Hz)

clear LCD for easy menu setting
5. Overview
Refer to the illustrations on page 2 of this manual.
1 mounting bracket
2 locking nut
3 DMX input (5-pole XLR)
4 DMX input (3-pole XLR)
5 DMX output (5-pole XLR)
6
DMX output (3-pole XLR)
6.

Installation

Choose a suitable mounting spot. Mount the device in the desired angle using the included bracket.
Connect the power cord to the mains. Disconnect after use.
Mounting the Device

Have the device installed by a qualified person, respecting EN 60598-2-17 and all other applicable
norms.

The carrying construction must be able to support 10 times the weight of the device for 1 hour
V. 01 – 19/06/2014
LX119
7 control panel
8 safety cable attachments
9 power input (powerCON)
10 power output (powerCON)
11 ground point
12
fuse holder
4 ©Velleman nv