Installation - Luxibel LX111 User Manual

 Familiarise yourself with the functions of the device before actually using it. Do not allow operation by
unqualified people. Any damage that may occur will most probably be due to unprofessional use of the
device.
 All modifications of the device are forbidden for safety reasons. Damage caused by user modifications to
the device is not covered by the warranty.
 Only use the device for its intended purpose. All other uses may lead to short circuits, burns, electroshocks,
lamp explosion, crash, etc. Using the device in an unauthorised way will void the warranty.
 Damage caused by disregard of certain guidelines in this manual is not covered by the warranty and the
dealer will not accept responsibility for any ensuing defects or problems.
 Mechanical wear and LEDs are not covered by warranty.
 A qualified technician should install and service this device.
 Do not switch the device on immediately after it has been exposed to changes in temperature. Protect the
device against damage by leaving it switched off until it has reached room temperature.
 This device is designed for professional use on stage, in discos, theatres, etc.
 The device should only be used indoors.
 Use the appropriate power supply (see Technical Specifications below).
 Lighting effects are not designed for permanent operation: regular operation breaks will prolong their lives.
 Use the original packaging if the device is to be transported.
 Keep this manual for future reference.
4. Features
 high power tri-colour LED panel for eye-candy effects, wash light or blinder effect
 each LED controllable for pixel mapping
 DMX controlled via 3, 5, 9, 10 or 13 channels
 built-in automatic programs via master/slave or DMX with variable speed
 2 x 8 digit LCD display for easy menu setting
 COB LED for superior RGB colour mixing
 additional power output
 bracket for multiple unit connection, to create a wall
 heavy duty bracket for truss rigging
 equipped with Neutrik powerCON in/out
5. Overview
Refer to the illustrations on page 2 of this manual.
1 power input + fuse holder
2 power output
3 DMX input
4 DMX output
6.

Installation

Choose a suitable mounting spot. Mount the device in the desired angle using the included bracket. Connect the
power cord to the mains. Disconnect after use.
Mounting the device
 Have the device installed by a qualified person, respecting EN 60598-2-17 and all other applicable norms.
 The carrying construction must be able to support 10 times the weight of the device for 1 hour without
deforming.
 The installation must always be secured with a secondary attachment e.g. a safety cable.
 Never stand directly below the device when it is being mounted, removed or serviced. Have a qualified
technician check the device once a year and once before you bring it into service.
 Install the device in a location with few passers-by that is inaccessible to unauthorised persons.
 Overhead mounting requires extensive experience: calculating workload limits, determining the installation
material to be used... Have the material and the device itself checked regularly. Do not attempt to install
the device yourself if you lack these qualifications as improper installation may result in injuries.
 For truss mounting, use an appropriate clamp (not incl.) and fit an M10 bolt through the centre of the
(folded) bracket.
V. 02 – 28/03/2013
LX111
5 built-in microphone
6 control buttons
7 display
8 bracket
4 ©Velleman nv