Loop Recording - Mobius 2 User Manual

USB Data Port Charging
Enables or disables charging the internal battery when USB is connected and the
camera is turned on.
•
When disabled, charging will only occur when the camera is turned off.
•
When enabled, charging will occur as soon as the USB is connected.
►This parameter should be set to 'Disabled' when the camera is used with hand held
devices in order to avoid draining the device's battery.

Loop Recording

Loop recording can be enabled or disabled by software or by manually editing the
syscfg2.txt file. It can be enabled or disabled separately for both Video Mode 1 and
Video Mode 2.
By default, Loop Recording is disabled in both Modes meaning the camera will
record clips until the card is full. The camera will then stop recording and enter
standby mode.
If Loop Recording is enabled, the oldest clips will be overwritten when the card is full.
As such, the camera will never stop recording and only the most recent clips will be
available on the card. Loop recording should normally be enabled if the Mobius 2 is
used as a dashcam.