Installing The Throat Plate; Cutting Through Insert - RIDGID MS1050 Owner's Manual

Alignment (Adjustments) (continued)
WARNING: To reduce the risk of injury from unex-
pected starting or electrical shock, do not plug the
saw in. The power cord must remain unplugged
whenever you are working on the saw.

Installing the Throat Plate

Find the following parts:
Item
No. Description
A Throat Plate ............................................................. 1
B Pan Head Screw 8-32 x 3/8 ..................................... 4
1. Unplug the power cord.
2. Position the throat plate in the opening in the base.
3. Install the screws and tighten.
WARNING: Cut material can be thrown. Eyes can
be permanently damaged. Wear your safety gog-
gles.
NOTE: Before this saw is aligned or used, a kerf must be
cut into the throat plate at 0° bevel and 45°bevel.

Cutting Through Insert

1. Plug in the power cord.
2. Turn the saw on by actuating the trigger switch.
3. Slowly lower the blade to full depth while cutting
through the throat plate.
4. Release the trigger switch and allow the blade to come
to a complete stop.
5. Repeat this procedure at 45° bevel.
6. Unplug the power cord before starting the alignment
procedures.
A
Qty.
14
B