VESPA 664787 Service Station Manual page 37

Vespa S 50 2T
3. If otherwise, adjust the right headlight with screw
«A».
N.B.
THE ABOVE PROCEDURE COMPLIES WITH THE EURO-
PEAN STANDARDS REGARDING MAXIMUM AND MINI-
MUM HEIGHT OF LIGHT BEAMS. REFER TO THE STATU-
TORY REGULATIONS IN FORCE IN EVERY COUNTRY
WHERE THE vehicle IS USED.
SAS filters inspection and cleaning
Remove the right side fairing by undoing the 2
screws marked «B» indicated in the figure.
Remove the two screws «A» from the aluminium
SAS cover. Release the metal tube from the rub-
ber housing on the cover without extracting the
tube from the cover/sleeve. Remove the tab and
plastic cover, extract the sponge and wash it in
water and soap. Dry it with compressed air before
refitting it, making sure to correctly fit the tab in the
housing on the two plastic and aluminium covers.
Every time you disassemble the filter, replace the
O-ring seal located in the cover.
Maintenance
MAIN - 37