VESPA 664787 Service Station Manual page 121

Vespa S 50 2T
- Pads must be replaced when the friction material
thickness reaches the wear limit.
- To replace:
remove the protection cover, the bolt and the leaf
spring. Slide off the pads and replace them once
the plungers are down. Carry out these operations
in reverse order to fit.
CAUTION
BEFORE USING THE BRAKE, OPERATE THE LEVER A
FEW TIMES.
Refitting
- Insert the brake pads
- Insert the fixing pin being careful to position the
clip with the ends towards the bleed screw as in
the photo.
- Insert the lock on the bolt and then the protection
cover
Fill
Braking system
BRAK SYS - 121