Battery Installation; Connection - Panasonic KX-T2315 Instructions Manual

BATTERY INSTALLATION

Three R6 (AA, UM-3) size batteries serve as the power source to activate
the SP-PHONE fully, and to retain the stored phone numbers in memory.
1) Remove the wall mounting adapter from the bottom of the unit.
2) Open the battery compartment cover.
3) Insert the three R6(AA,UM-3) size batteries observing the correct
polarity, then close the compartment cover.
4) Insert the tabs of the wall mounting adapter into the openings of the unit,
then push it in the direction of the arrow. (The word "DESK UP"
on the adapter should be upward.)
NOTE:
n Please check your batteries before calling telephone repair.
n To prevent loss of the stored telephone numbers, replace new batteries within
10 minutes after removing the old ones.
Disconnect the telephone cord before opening the battery compartment cover.
n
Replace all the batteries once a year, or mis-operation may occur.
n
n Do not use Nickel-Cadmium batteries.
BATTERY PRECAUTIONS:
The batteries should be used correctly, otherwise, the unit may be damaged
n
due to battery leakage.
n Do not mix different types of batteries.
n Do not charge, short-circuit, disassemble, heat or dispose in fire.
n Remove all the batteries when replacing.

CONNECTION

1) Connect the handset: Fasten the handset cord to the holder at the bottom of
the unit.
2) Connect the telephone line cord: Connect cord to single-line telephone jack
(RJ11C)
NOTE:
Use only Panasonic handset for the KX-T2315.
n
5