Battery; Battery Installation; Battery Charge - Panasonic KX-TCD510RUM Service Manual

KX-TCD510RUM / KX-TCD510RUT / KX-TCD510RUV / KX-TCD512RUM / KX-TCD512RUT / KX-TCD512RUV

4 BATTERY

4.1.

Battery Installation

Please ensure the batteries are inserted as shown.
Close the cover as indicated by the arrow.
· When you replace the batteries,
4.2.

Battery Charge

At the time of shipment, the batteries are not charged. To charge, place the handset on the base unit.
Please charge the batteries for about 7 hours before initial use. During charging, the charge LED will light as shown below.
The handset which power is off will be turned on automatically when it is placed on the base unit.
The handset will not operate while it is on the base unit.
If you do not recharge the handset battery for more than 15 minutes, the display will flash
the base unit.
Note for Service:
· The battery strength may not be indicated correctly if the battery is disconnected and connected again, even after it is fully
charged.
In that case, by recharging the battery as mentioned above, you will get a correct indication of the battery strength.
· Confirmation of Antenna Pict (
If Antenna Pict is indicated, charge time is about 7 hours.
However, if Antenna Pict is flashing, charge time becomes long.
part should be inserted first.
part should be removed first.
) indication:
8
when the handset is lifted off