Initilaize Operation - Casio TE-2000 Service Manual

2. INITIALIZE OPERATION
Initializing the cash register
•
Automatic initialization
Use the following procedure to initialize the cash register before using it for the first time after you purchase it.
1. Install the three memory backup batteries (see page 7 of the User's Manual).
2. Plug the cash register into a wall outlet.
•
At this time, "00000000" appears on the display and the printer operates for a few seconds. Initialization is
complete when the printer stops operating.
CAUTION!
Automatic initialization (which clears all sales and programming data stored in the register's memory) is
performed whenever all power (both the backup batteries and power through power cord) is cut from the cash
register and then restored.
Remember...
Main power cut by :
• Unplugging the cash register
• Power failure
•
Manual initialization
Use the following procedure to initialize the cash register and clear all transaction data and program data from
its memory.
1. Insert the mode key marked "PGM" into the mode switch.
2. Turn the mode switch to the OFF position.
3. While holding down the
JOURNAL
4. Release the
FEED
•
At this time, "00000000" appears on the display and the printer operates for a few seconds. Initialization is
complete when the printer stops operating.
To select the monetary system and date format
Use the following procedure to specify the number of monetary decimal places the date format. This setting
should be performed immediately after you initialize the cash register.
INITIALIZATION
CAL
REG
OFF
RF
PGM
Language selection
This specification defines the
language to use for the date in
receipt/journal printing.
English/German
for Germany: German
for Other area: English
French
Spanish
Backup power cut off by:
• Removing the batteries
+
• Dead or low batteries
JOURNAL
key, turn the mode switch to the PGM position.
FEED
key.
X
Z
3 SUB 1 2
TOTAL
Date format
This specification defines the
format to use for the date in
receipt/journal printing.
0
Year-Month-Day
Day-Month-Year
1
Month-Day-Year
2
Automatic initialization when
=
the main power is restored and
the mode switch is set to any
position besides OFF.
2 SUB
TOTAL
Monetary system
This specification defines the
memory system to apply to all
registrations.
0
No decimal place
2
One decimal place
1
Two decimal places
— 3 —
CA AMT SUB
= TEND
TOTAL
0
1
2