Table of Contents
Advertisement
18.2 IN "FAT 16" MODE
"WRONG USB VERSION"
"CARD FULL"
"OPEN WRITE ERROR"
"WRITE ERROR"
"READ ERROR"
"CARD TOO SLOW"
"DIRECTORY FULL"
"CARD NEARLY FULL"
"KEYPAD LOCKED"
"AUTO POWER OFF"
"LOW BATTERY"
"NO AUTO POWER OFF"
"INVALID CARD"
"NO CARD"
"UNKNOWN FORMAT"
"DIR UNUSABLE "
"CARD READING..."
"CARD BUSY..."
"USB MODE"
19 SOFTWARE UPDATE
A small black 6 pin connector is located just under the flashcard. This connector is a RS232
connector. A special adapter "NP-PCA" is needed to connect the RS232 from the machine to a PC or
laptop.
When new software from NAGRA becomes available, it can be delivered by Email or it can be down-
loaded from the NAGRA web site. By using the PC software called "PuserLoader" the machine can
be updated with the new software version. This takes about 2 to 3 minutes.
Issue: January 2004
DSP and USB software versions are incompatible
No more memory available on the card
Defective card or card error
Defective card or card error
Defective card or card error
Depending from the selected file format, some cards do not
accept a high recording bit rate
999 takes (files) already recorded
60 seconds recording time left on the card
The full keypad is locked
The machine will switch of in the nex t 15 seconds
The battery voltage has dropped too low
Auto power off has been disabled
The card is not recognized by the machine
No card inserted in the slot
The card is recognized but not the type of format
The "ARESP" folder cannot be created
Example: an ARESP file name was already present
Appears during the directory reading
Appears when the card is busy
Example: delete to end or renumbering
The card is accessed via USB
Page 22
Advertisement
Table of Contents
