Installation Instructions - KORTING KIT-614-ESC Instructions For Use, Installation, And Connection

SYMPTOM
A fuse blows as soon as the
hob is switched on.
The hob simply switches off.
The hob has stopped operating
and is beeping approximately
every 10 seconds and a
displayed.
A series of small is
displayed.
Fault code F9
Other fault codes.

Installation instructions

What you need to
consider
16
POSSIBLE CAUSE
The hob has been wrongly
connected.
You accidentally touched the
On/Off button or touched two
buttons at the same time.
The control panel is fi lthy or
has water on it.
is
The hob has overheated.
The voltage is too low
and/or the hob is not properly
connected.
Defective generator.
Safety instructions for the installation
• The connection must comply with national and local
regulations.
• The appliance must always be earthed.
• This appliance may only be connected by a competent
electrical installer.
• For the connection, use an approved cable in accordance with
the regulations. The cable casing should be of rubber.
• The connection cable must hang freely and is not to be fed
through a drawer.
• If you want to make a fi xed connection, make sure that a multi-
polar switch with a contact separation of at least 3 mm is fi tted
in the supply line.
• The worktop the hob is built into must be fl at.
• The walls and the worktop surrounding the appliance must be
heat resistant up to at least 85 °C. Even though the appliance
itself does not get hot, the heat of the hot pan could discolour
or deform the wall.
• Damage caused by incorrect connection, installation or use,
will not be covered by the guarantee.
SOLUTION
Check the electrical
connections.
Switch the hob back on.
Clean control panel.
Let the hob cool down and then
use a lower setting.
Have your connection changed.
Contact the service
department.