Panasonic AJ-HD3700B Operating Instructions Manual page 33

Basic operations
When TC INPUT is set to the REVERSE mode*
(1) Press the cursor center key to display the cursor.
The time code value will be highlighted.
(2) Move the cursor with the cursor key (4) to the CUE TIME display section.
The cue display section will be highlighted.
(3) Press the cursor center key again to change it to a bar cursor.
Enter the cue point with the number keys.
0
(4) Press the ENT key.
The cursor will disappear.
(5) Press the PREROLL button.
PREROLL
*The REVERSE mode is set using the F9 key on the PANEL SET UP menu. (This key can be set in
either the STANDARD or REVERSE mode.)
Cursor center key
Cursor key
H
≥Cue points also can be entered by pressing the ENTRY button.
4 4
In this case, the time data of the current tape position will be
entered.
7 0 4
00 44
H
≥When the PREROLL button is pressed, cue-up operation will
start, and the tape will stop at the preroll point (the point pre-
ceding the cue point by the preroll time).
≥To stop at the cue point, either set the preroll time to "0" or
press the F key and PREROLL button together. (This results in
the cue-up operation.)
LTCR
00 : 00 : 00 : 00
Cursor
CUE TIME
M S F
Cursor
CUE TIME
07 04
M S F
– 33 –
ENTRY