Rack-Mounting - Panasonic AJ-HD3700B Operating Instructions Manual

Rack-mounting

The VTR can be installed in a 19-inch standard rack using the AJ-MA37P rack-mounting adapters (optional
accessory).
It is recommended that the slide rail (CC3001-99-0191) made by Chassis Trak be used as the installed rails.
For further details, consult your dealer.
1. Attach the inner members on each side of the VTR using the four screws supplied with the
slide rails .
The length of the screws used is limited.
If the mounting screws have been lost or misplaced, use screws with a maximum length of
2/5˝.
Be absolutely sure to attach the inner members to the VTR using the screws for all of the
four holes.
2. Mount the outer member brackets onto the rack.
Check that the height of the brackets is the same at the left and right.
3. Remove the two front screws on the VTR's two side panels.
4. Mount the AJ-MA37P rack-mounting adapters using the four supplied M4 screws with spring
washers.
5. Mount the VTR in the rack.
After mounting the VTR, check that it moves smoothly along the rails.
≥Keep the temperature inside the rack within the i41 °F (5 °C) to 104 °F (40 °C) range.
≥Bolt the rack securely to the floor so that it will not topple over when the VTR is drawn out.
Rack-mounting adapter
EIA standard rack
Secure the VTR to the
rack here using the
anchoring screws.
– 50 –