Panasonic AJ-D950 Operating Instructions Manual page 75

Counter display
REEL DIR UNMATCH REEL DIR UNMATCH
REEL TENSION ERROR
REEL TENSION ERROR
SERVO COMM ERROR SERVO COMM ERROR
SERVO CONTROL
SERVO CONTROL
ERR
ERROR
SERVO ERROR SERVO ERROR
S-FF/REW TIMEOVER
S-FF/REW TIMEOVER
S REEL ROTA TOO S REEL TOO FAST
FAST
S REEL TORQUE S REEL TORQUE
ERROR ERR
T REEL TOO FAST
T REEL ROTA TOO
FAST
T REEL TORQUE T REEL TORQUE
ERROR ERR
UNLOAD ERROR
UNLOAD ERROR
WINDUP ERROR WINDUP ERROR
WINDUP REEL NOT W-UP REEL NOT ROTA
ROTA
Monitor display
If the reel motor at the take-up side is running in the
reverse direction, the AUTO OFF lamp lights, and the
message display flashes.
If an abnormal tension at the supply side is detected
in the reel mode, the AUTO OFF lamp lights, and the
message display flashes.
When the servo microcomputer does not follow the
instructions of the system control microcomputer even
when 10 seconds have elapsed, the AUTO OFF lamp
lights, and the message display flashes.
When there is no response from the servo micro- S T O P
computer for 1 or more seconds, the AUTO OFF
lamp lights, and the message display flashes.
When only the servo microcomputer was reset in an
instantaneous power failure, the AUTO OFF lamp
lights, and the message display flashes.
If the start/end processing operation is not completed,
the AUTO OFF lamp lights, and the message display
flashes.
If the supply reel motor should rotate at an abnormally
fast rate, the AUTO OFF lamp lights, and the message
display flashes.
If
an abnormal torque applied to the supply reel motor
is detected or if an abnormal current flowing to the
current-sensing resistor is detected, the AUTO OFF
lamp lights, and the message display flashes.
If the take-up reel motor should rotate at an ab-
normally fast rate, the AUTO OFF lamp lights, and
the message display flashes.
If an abnormal torque applied to the take-up reef
motor is detected, the AUTO OFF lamp lights, and
the message display flashes.
If the tape has not been wound up during unloading,
the AUTO OFF lamp lights, and the message display
flashes.
If, after the total tape amount has been detected, the
amount of tape wound up on the take-up reel and the
amount of tape supplied by the supply reel differ to an
abnormal extent while the tape is traveling in the
forward or reverse direction, the AUTO OFF lamp
lights, and the message display flashes.
If, after the cassette has been inserted, the tape take-
up reel has not wound up the tape while the total tape
amount is not detected and while the tape is traveling
in the forward or reverse direction, the AUTO OFF
lamp lights, and the message display flashes.
- 7 5 -
Description
VTR operation
(Restart condition)
STOP
(POWER OFF ON)
STOP
(POWER OFF ON)
STOP
(POWER OFF ON)
(POWER OFF ON)
S T O P
(POWER OFF ON)
STOP
(POWER OFF ON)
STOP
(POWER OFF ON)
STOP
(POWER OFF ON)
STOP
(POWER OFF ON)
STOP
(POWER OFF ON)
STOP
(POWER OFF ON)
STOP
(POWER OFF ON)
STOP
(POWER OFF ON)