Table of Contents
Advertisement
MAINTENANC
©
LIGHT REPLACEMENT
OVEN DOOR
LEVELING LEGS
Before replacing even light bulb, DIS-
Do not place excessive weight on an
Some floors are not level. For proper
CONNECT POWER TO RANGE. Be
open oven door or stand on an open
baking, your range must be level. Level-
surebulb is cool. Do not toucha hot bulb
oven door as, in some cases, it could
ing legs are located on each corner of
with a damp cloth as the bulb may
cause the range to tipover, breakage of
the base of the range. Level by turning
break,
the door or serious injury,
the legs.
Very carefully remove bulb with a dry
When opening oven door, allow steam
potholder to prevent possible harm to
and hot air to escape before reaching in
_ _
j
hands. Replacewith a 40watt appliance
oven to cheek, add or remove food.
bulb. Reconnect power to range and re-
set clock, if equipped.
To remove lift-off door: Open door to
the "stop" position (opened about 4
STORAGE DRAWER
inches) and grasp door with both hands
at each side. Do not use door handle to
The storage drawer at the bottomof the
lift door. Lift up evenly until door clears
range is safe and convenientfor storing
the hinge arms.
To prevent range from accidently tip-
metal and glass cookware. DO NOT
ping, range should be secured to the
store plastic, paperware, food or flare-
floor by sliding rear leveling leg into the
mable material in this drawer. Remove
_
anti-tip bracket supplied wRhthe range.
drawer to clean under range.
To remove: Empty drawer then pull
FUSES
O
drawer out to the first stop position. Lift
(CANADIAN RANGES ONLY)
upfront of drawer and pull to the second
Your range is equipped with seven (7)
stop position. Grasp sides and lift up
type "P"fuses. Thefuses are located on
and out to remove drawer,
the back wall of the range. Remove the
storage drawer for access to the fuses.
To replace: Fit ends of drawer glides
onto rails. Lift up drawerfront andgently
CAUTION:
push in to first stop position. Lift up
Hinge arms are spring mounted and
I
I!
I
drawer again and continue to slide
willslamshutagainsttherangeifacci-
drawer to the closed position,
dently hit, Never place hand or fin-
gers between the hinges::and the
front oven frame, =Youcould be in-
lured if hinge snaps back.
To replace door: Grasp door at each
side, align slots in the door with the
hinge arms and slide door down onto
the hinge arms until completely seated
If part of your range does not operate,
on hinges,
check to see if a fuse has blown. A gap
in the fuse strip or a darkened window
indicates a blown fuse. Replace with the
Do not attempt to open or close door
same type and amperage type "P" fuse.
until door is completely seated on
hingearms. Never turnon oven unless
door is properly in place. When bak-
ing, besure door is completely closed.
Bakingresultswillbeaffected ifdoor is
not securely closed,
-11-
Advertisement
Table of Contents
