Specifications - Watkiss spinemaster Operating Manual

Intended Use
Production
Booklet Size
Booklet Thickness
Dimensions
Electrical
Operating Conditions
Radio Frequency
Emissions
Watkiss Automatic SpineMaster Operator Guide - Issue 1a - April 2004

6 Specifications

This product is intended for the re-forming of booklet
spines, to flatten the booklet and give a square appear-
ance to the spine, within the specifications below.
up to 1400 per hour single pass
from 80 x 120mm to 250 x 350mm
(dependant on specification of connected equipment)
minimum of 1mm, 0.04"
maximum of 6.5mm, 0.25". This is approximately 30
sheets of 80gsm (20# bond) folded into a 120 page
booklet.
Width 707mm, 28"
Depth 745mm, 29.5"
Height 1242mm, 49"
Weight 132kg, 291lb
230V, 50Hz, 3A or 115V, 60Hz, 5A
Single Phase, Earthed supply required
Noise 72 dB(A)
10-35°C at 35-85% relative humidity
Production and specifications are subject to operating
conditions. The specified paper thickness figures are
given for guidance only. The actual performance of the
machine will depend on the nature of the paper and
covers used. In line with a policy of continual improve-
ment, the manufacturer reserves the right to alter the
materials or specifications of this product at any time
without notice.
This equipment has been tested and found to comply with
the limits for a Class A digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when
the equipment is operated in a commercial environment.
This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accord-
ance with the instruction manual, may cause harmful
15