Table of Contents
Advertisement
Figure 34:
The circular portion of the bracket should be facing to the side of the AP (the AP's sides are the faces
that do not have antennas or other attachments). This is to ensure that the AP is properly oriented
when the bracket is fully assembled.
Insert the circular portion of the bracket attached to the AP into the hollow cone portion of
6.
the bracket on the wall. The two should fit somewhat snugly, although a screw assembly
will be required to hold them in place.
Run one of the long screws provided in the package down through the hole that runs
7.
through both portions of the bracket. The head of the screw should fit into the hexagonal
slot on the top of the bracket assembly.
On the other end of the screw (i.e., the one that doesn't have the hexagonal head), slide a
8.
flat washer and then a lock washer into place. The flat washer should be against the base
of the mounting assembly.
Screw one of the hexagonal nuts into place on top of the two washers. Once tightened,
9.
the nut should force the lock washer into place and the two bracket components should
be locked together.
Connect the Ethernet cable to the controller and verify that all antennas are securely con-
10.
nected.
58
Square Mounting Bracket Attaches to Bottom of OAP433e
Installing the Access Point
Advertisement
Table of Contents
