4
Installing AP433e
This chapter describes how to install and configure an AP433e, which is supported on System
Director versions 6.0-SR1 and later. It contains the following sections:
•
"Safety Precautions"
•
"Unpack the AP433e"
•
"Determine Power Requirements"
•
"Installation Requirements"
•
"Install the AP433e"
•
"Check AP433e LED Activity"
•
"Where to Go From Here"
Safety Precautions
IMPORTANT—Read and follow the regulatory instructions in Appendix G before installing and
operating this product.
The AP433e is intended only for installation in Environment A as defined in IEEE 802.3af and
802.3at. All interconnected equipments must be contained within the same building, including
the interconnected equipment's associated LAN connection.
Unpack the AP433e
Confirm that the AP433e shipping package contains these items:
•
AP433e
•
Nine (9) external antennas
•
Wall mounting bracket
•
Rubber feet
•
Locking pin
Safety Precautions
on page 33
on page 33
on page 34
on page 34
on page 35
on page 46
on page 48
33