Table of Contents
Advertisement
After the AP433i is connected, check the status of the LEDs. The functions of the LEDs are
described below.
AP433i LED Descriptions
Power
Status
Change LED Appearance
If you want to change the appearance of the LEDS, follow these steps:
From the controller, click Configuration > Devices > AP, and then select the AP.
1.
Select one of these settings for the LED Mode setting:
2.
•
•
•
Click OK.
3.
Where to Go From Here
Now that the AP433i is installed, go to the
for instructions on initializing the hardware. Return to this chapter to check the status
of the LEDs once the WLAN is operational.
Where to Go From Here
LED
off—no power
green—presence of power
off—no power
green—booting stage 1
blinking green and off—booting stage 2
blinking green and white—discovering
the controller
blinking green and blue—downloading
a configuration from the controller
blinking blue and off—AP is online and
enabled, working state
blinking red and yellow—failure; con-
sult controller for alarm state
Normal: LEDs are as described above
Blink: Sets all LEDs flashing; this is useful to locate an AP
Dark: Turns off all LEDs
Function
Meru System Director Getting Started Guide
Troubleshooting
If the status LED is blinking red
and yellow, there is an alarm on
the AP. Determine what the alarm
is by clicking Monitor > Dash-
board > Alarms and looking at the
AP alarms. You can also use the
CLI commands show alarm and
show log.
31
Advertisement
Table of Contents
