Assembly Instructions - Makita PM7650H Owner's And Safety Manual

ASSEMBLY INSTRUCTIONS

ASSEMBLY OF MIST BLOWER PIPES
CAUTION: Before performing any work on the mist blower, always stop the
engine and pull the spark plug connectors off the spark plug.
Always wear protective gloves!
CAUTION: Start the mist blower only after having assembled it completely.
1. Assemble pipe with swivel (3) into flexible pipe (1) and tighten
diameter 76 mm (2).
(2)
(1)
2. Assemble flexible pipe to elbow (4) on
diameter 100 mm (5).
3. Assemble straight pipe (6) to pipe with swivel and tighten
76 mm (2).
Assemble second nozzle to straight pipe by tightening hose band diameter
76 mm (2).
Note: The straight pipe stated above means the following three pipes and can be
substituted depending on your work need.
• Straight pipe (this one) (8)
• Straight pipe (short) (7)
• Bent top pipe (9)
Only one or combination of the above pipes is supplied as a standard
equipment with your mist blower, which may differ from country to country.
The remaining types of pipes may need to be obtained as optional
accessories.
4. Make sure all clamps are tight.
hose band
(3)
mist blower and tighten hose band
hose band diameter
11
(4)
(2)
(2)
(6)
(7)
(5)
(8)
(9)