Connect To The Nvr; Use Seenergy Device Search Utility - Seenergy svr-632s Quick Manual

Connect to the NVR

There are various ways you can connect to the NVR and below are the
suggested methods for different network setup:
• The NVR is placed in a network with a DHCP server: Connect to
the NVR by using "SEEnergy Device Search" Utility
• The NVR is placed in a network without DHCP server (or you are
connecting to it directly): Access the NVR with its default IP
* Please install Ethernet cable on Ethernet 1 port of SVR-632S.

Use SEEnergy Device Search Utility

If the NVR is placed in a corporate network or a local area network
where a DHCP server is already presented, run the "SEEnergy Device
Search" utility from a computer that is on the same network and locate
the NVR with its IP address that is assigned by the top-level DHCP
server.
SVR-632U & 632S Quick Guide 11