Diagnostic And Service Tools; Conventions; Parts And Service; Modifications - Clarke SA40 56104487 (20D) Service Manual

Service Manual – SA40 General Information 7

Diagnostic and Service Tools

In addition to a full set of metric and standard tools, the following items are required in order to successfully
and quickly perform troubleshooting and repair of Advance commercial floor cleaning equipment.
• Digital voltmeter (DVM) with DC current clamp
• Hydrometer
• Battery load tester for checking batteries
• Set of torque wrenches
These tools are also available from Nilfisk-Advance, Inc.:
• Curtis 1311 hand held programmer, p/n 56409441,
• Vacuum water lift gauge, p/n 56205281.

Conventions

All references to right, left, front and rear in this manual are as seen from the Operator's position.

Parts and Service

Repairs should be performed by an Authorized Advance Service Center that employs factory-trained service
personnel and maintains an inventory of Advance original replacement parts and accessories.
Call the Advance Dealer named below for repair parts or service. Please specify the Model Number (same as
the Part Number) and Serial Number when discussing your machine.

Modifications

Modifications and additions to the cleaning machine which affect capacity and safe operation shall not be
performed by the customer or user without prior written approval from Nilfisk-Advance Inc. Unapproved
modifications will void the machine warranty and make the customer liable for any resulting accidents.

Nameplate

The Model Number (Part No.) and Serial Number of the
machine are shown on the located on the inside of
Nameplate
the battery compartment.
This information is needed when ordering repair parts for the
machine.