Eddie Bauer SureFit User Manual page 27

2.
3.
4.
cannot grasp the vehicle belt at the latch plate, grasp the
vehicle belts on the opposite side of the child restraint, as
close to the latch plate as possible.
5.
51
Thread Vehicle Belt
Thread vehicle lap belt
through the belt path (as
shown).
Buckle the vehicle belt.
Tighten Vehicle Belt
Lay your forearm across
child restraint at the belt
path while pulling up on
belt to tighten.
Locate Locking Clip
Location
Grasp both vehicle belts
together just behind the
latch plate and unbuckle.
NOTE: If the latch plate
ends up just at the belt
path opening so you
Attach Locking Clip
Thread both portions of
the vehicle belt onto the
locking clip, as close
to the latch plate as
possible.
6.
7.
(2.5 cm). NOTE: If it moves more than 1 in. (2.5 cm),
try reinstalling the child restraint or try another seating
location.
8. Reheck Angle Indicator
Check the angle indicator
(1.8-4.9 kg)
while parked on level
4-11 lb
ground. The ball should be
in the zone that matches the
11-35 lb
weight of your child.
(4.9-15.9 kg)
Repeat steps 1-7 if not
reclined correctly.
You may need to place a
large rolled towel or foam
pool noodles under the
when the seat belt is not being used with a child
restraint.
52
Position Locking Clip
Position locking clip
about 1 in. (2.5 cm) from
vehicle belt's latch plate.
Rebuckle vehicle belt.
Check Belt Tightness
Grasp the child restraint
at the belt path with one
hand. Push and pull the
child restraint from side
to side, forward and back.
The child restraint should
not move more than 1 in.
front of the base to achieve
correct recline angle.
Check often to be sure
padding is still in place and
the belt is tight.
Remove the locking clip