Conversion - Ormed ARTROMOT-K4 Operation Manual

Use an appropriate tool to remove the
fuse holder situated between the power
switch and the power connector
(Fig. 1). Replace the fuses and reinsert
the fuse holder (Fig. 2). Ensure that the
fuse holder properly locks into place.
Fig. 1
Fig. 2

6.3 Conversion

The ARTROMOT ® -K4 allows the
patient's knee and hip pivot to be
adjusted once.
For this purpose, the carriage may have
to be reconfigured from left to right.
With this reconfiguration feature, the
anatomical accuracy of the carriage is
outstanding.
1. To begin with, set the carriage to a
knee angle of 80° to 90° (see also:
5.1) and stop it there.
2. Pull on the locking pin (11) for the
height adjustment of the carriage hip
pivot and remove the height adjust-
ment from the carriage. (Fig. 9)
3. Hold the height adjustment. Remove
the entire femur length adjustment (8)
mechanism: To do so, open the
bayonet lock by turning it a quarter
revolution and pull the mechanism
from the holding tube. (Fig. 10)
4. Attach the femur length adjustment
mechanism on the other side. To do
so, observe the instructions given at
3, reversing the order.
Note!
For the correct assembly and locking
of the bayonet lock, please observe
the sticker on the ARTROMOT
5. Now press the buttons (13) simulta-
neously and pull the length adjust-
ment for the hip height adjustment
from the carriage housing. (Fig. 11)
6. Then insert the length adjustment for
the hip height adjustment into the
carriage housing on the other side
until you hear it engage.
7. Pull on the locking pin (11) for the
height adjustment of the carriage hip
pivot and reinsert the height adjustment
into the holding tube. When the correct
height is reached, release the locking
pin to fix the set height. (Fig. 12).
21
® -K4.
Fig. 9
Fig. 10
Fig. 11
Fig. 12