Table of Contents
Advertisement
11 o'clock, but the physical FEEDBACK knob is set to 3 o'clock.
In order to quickly find the current preset's settings, the display is used to indicate
knob position. Once a knob starts to rotate, the display will show whether the knob is
set too high or too low, similar to the way an electronic tuner works. The upper line of
the display is lighted if the current knob position is higher than the preset setting, and
the lower line of the display is lighted if the current knob position is lower than the
preset setting. Once the knob position is aligned with the preset setting, the middle line
of the display will light.
Editing a Preset
When turning knobs, the control will not engage until the knob position reaches the
setting of the currently loaded preset. For instance, in the previous example, turning
the FEEDBACK knob will not change the sound until the knob reaches the 11 o'clock
position. Once the FEEDBACK control is engaged, it will behave like an ordinary active
knob. If changes are made to the knob settings from that of the loaded preset, the
yellow PRESET EDITED LED will light.
Saving a Preset
All knob settings can be saved to the current preset number at any time by simply
pressing and holding the DELAY TIME knob for 5 seconds. All of the LEDs will flash to
indicate the preset has been saved.
If a preset is saved with TAP MODE enabled, then tap tempo will be available for the
preset. For example, if a tempo is tapped in while the pedal is bypassed, this saved
preset will then use that tempo when the pedal is enabled (see TAP MODE section on
page 8 for more details).
OPERATING MODES
The Time After Time has up to 11 available user presets. These presets can be loaded
either via MIDI, or by the pedal's footswitches. There are two available modes for
accessing presets with the footswitches. The mode you use will depend highly on your
performance requirements.
PRESET MODE
PRESET MODE is designed to give the most accessibility to the presets and TAP
MODE functionality. This is the default factory set mode.
In PRESET MODE, the numeric display indicates the actual preset number. The 'B'
footswitch is used to enable or bypass the pedal, and the 'A' footswitch is used to scroll
through the available presets. When the pedal is bypassed, the display will show the
6
Advertisement
Table of Contents
