Troubleshooting - Breville Hot Cup Instructions For Use Manual

Troubleshooting

Problem
The start switch will not stay
in the on position.
The water tank does not
illuminate and your Hot Cup
does not dispense boiling
water.
Your Hot Cup does not
dispense a full cup of water
Your Hot Cup produces
excess steam but does not
dispense boiling water.
Your Hot Cup makes a
noise and there is a 'clunk'
sound after water has been
dispensed.
Water drips from the
dispensing nozzle after the
boil cycle has finished.
Steam comes out from behind
the start button and behind
the dispensing nozzle
The water reservoir is getting
hot.
Your Hot Cup immediately
turns iteslf on when it is
placed on the power base.
12
Possible Cause
Your Hot Cup has not reset
itself after the boiling cycle.
• Your Hot Cup is not
plugged in.
• Your Hot Cup is not
positioned correctly on its
power base.
• The fuse has blown.
• Your Hot Cup has boiled
dry.
• Your Hot Cup has
excessive scale.
• The dispensing control may
be set too low.
• The water level has
dropped below the MIN
level.
• Your Hot Cup has
excessive scale.
This is the sound of the
internal valve operating after
the boil cycle finishes.
There is a residual amount
of water left inside your Hot
Cup after the boil cycle.
Steam is being vented in a
controlled manner through
designed vents
Hot water is being returned
to the water reservoir
Your Hot Cup is already
switched on.
Solution
Your Hot Cup is still too hot
after the last boil cycle. Wait
a few seconds for it to cool
slightly before trying again.
• Check your Hot Cup is
plugged in and switched on
at the supply socket.
• Check that the dispensing
nozzle is positioned
centrally over the drip tray.
• Check the fuse in the plug.
• Allow your Hot Cup to
cool down completely then
refill it with water.
• Descale your Hot Cup
• Adjust the dispensing
control
• Fill with water between
the MIN and MAX
markings then restart the
boil cycle.
• Descale your Hot Cup.
This is normal operation.
This is normal operation
This is normal operation
This is normal operation.
Press the stop button.