Settings - Panasonic SC-HT65 Operating Instructions Manual

Settings

Change the settings to suit your equipment
to the environment in which you are using
it. Before making any changes, read the
descriptions of the settings, note the factory
settings and ranges, and refer to the
equipment's instructions.
Enter the
1 2
setup mode.
2a
MENU
SETUP
RETURN
Press and hold.
2b
• Enter the distance of the front, center and surround speakers from
Distance
the seating position.
Change the distance so that the sound from all the speakers (except for the
subwoofer) reaches you at the same time.
You can select distances between 1.0 and 10.0 m.
The factory settings are:
L, R (front):
C (center):
SL, SR (surround):
• Reset the settings done in auto speaker setup.
Auto setup
YES: Reset all auto speaker setup settings
NO: To cancel (factory setting)
• This unit automatically detects whether input is digital or
Input mode
analog, but you can fix the input mode.
AUTO: The unit automatically detects whether input is digital or analog.
ANALOG: Select to make the unit accept analog input.
DIG: Select to make the unit accept digital input.
PCMFIX : Select to input to PCM.
1
1 In rare cases, the unit may have trouble recognizing PCM signals and this may cause the beginnings of tracks to be cut off.
Select "PCMFIX" if this occurs.
• With DTS, the signals may not be recognized at all. Engage the DTS FIX mode if this occurs.
To engage the DTSFIX mode:
Press and hold [-MENU] and [ENTER] at the same time. "DTS" lights.
To cancel the DTS FIX mode:
Press and hold [-MENU] and [ENTER] at the same time.
The mode cancels when input mode is set to AUTO or when the unit is turned off.
Note
When a FIX mode is on, the unit cannot process other signals. This may cause noise to be output. If this occurs, select an
input mode other than PCMFIX, or cancel the DTSFIX mode.
SC-HT65 GN-En.indb 13
Switch on.
Select the item you want to change.
TUNE
Select and press [ENTER].
DISTANCE ↔ AUTO SETUP ↔ INPUT
MODE ↔ HDMI ↔ DRCOMP ↔
ATTENUATOR ↔ REMOTE ↔ TV DELAY ↔
RESET ↔ EXIT
• Refer to pages 13 and 14 for each item settings.
• For "REMOTE", refer to page 22.
• For "RESET", refer to page 20.
Select and press [ENTER].
3.0 m (meters)
3.0 m (meters)
1.5 m (meters)
MENU
TUNE
SETUP ENTER
RETURN
Change the
3
setting.
ENTER
Press to change the
setting.
Press once to enter.
Display
MENU TUNE
SETUP
ENTER
RETURN
SETUP MIC
Exit the
4
setup mode.
MENU
SETUP
TUNE
RETURN
P r e s s r e p e a t e d l y
until "EXIT" appears.
ENTER ENTER
Press [ENTER] to
completely exit the
setup mode.
2a 2b
DISTANCE L
R
C
SL
SR
Repeat for each speaker channel
AUTO SETUP DEFAULT
INPUT MODE TV
DVR
DVD
(continue on next page)
3
1.0m to
10.0m
NO
YES
AUTO
ANALOG
DIG
PCMFIX
13
8/17/2007 4:20:14 PM