Troubleshooting For Auto Speaker Setup - Panasonic SC-HT65 Operating Instructions Manual

Auto speaker setup

Start performing auto
speaker setup.

Auto speaker setup finishes.
To cancel during setup
Press any button on the main unit or remote control. "CANCELED" appears on the display.
Note
Perform auto speaker setup again if you have changed the speakers, speaker positions, or the layout of your listening environment.
Depending on the speakers, room environment, and speaker placement, you may get different results for lowpass
filter frequency and other items even when you are using the same speakers. The results are based on small speaker
configuration.
(The calibration will give optimal result for "Distance". Therefore, you are not able to check the setting in page 13 while auto speaker
setup is in use.)

Troubleshooting for auto speaker setup

While performing auto speaker setup, errors may occur and the messages will blink or scroll on the display, depending on the
conditions. Press any button on the main unit or remote control to stop the setup.
After troubleshooting, press and hold
Message
"INSERT MIC"
"CHECK CONNECTION TO
LS/RS SPEAKERS"
"CHECK CONNECTION TO
L/R SPEAKERS"
Note
• Auto speaker setup may produce an unsatisfactory result with some speaker setups and configurations.
• Auto speaker setup will not start if you have muted the speakers. Turn the muting off (➡ page 20).
• Auto speaker setup will not start if you have plugged in headphone. Unplug any headphone.
• VIERA Link "HDAVI Control
12
SC-HT65 GN-En.indb 12
a) Press and hold
• [AUTO SPEAKER SETUP] indicator starts flashing.
AUTO
SPEAKER SETUP
• "AUTO SETUP" appears on the display.
b) The unit checks that you have correctly
connected the calibration microphone.
c) The automatic setup starts with STEP 1, STEP 2,
and STEP 3 calibration as follows.
STEP 1 (DETECTION/DISTANCE)  STEP 2 (SIZE/FREQUENCY)
 STEP 3 (LEVEL)
For your reference
• Loud test tones are output from each speaker during the configuration.
• During setup, operations may stop when there is an error message on the display.
Refer below for troubleshooting.
• "COMPLETE" appears on the display and all calibrations are saved.
• [AUTO SPEAKER SETUP] indicator lights.
• To exit, press and hold
• Disconnect the calibration microphone.
AUTO SETUP
to start the setup process again.
• Calibration microphone is not detected. Insert the microphone correctly.
• One or both surround speakers not detected. Check the connections.
• Check the front (L) and (R) connections.
TM
" (➡ page 8) is disabled during auto speaker setup.
• Turn off all components before making any connections.
• Peripheral equipment and cables sold separately
unless otherwise indicated.
• To connect equipment, refer to the appropriate
operating instructions.
AUTO SETUP
.
AUTO
SPEAKER SETUP
AUTO SETUP
.
Solutions
RECEIVER TV
AV
SYSTEM TV
^
^
VOLUME
TUNER BD/DVR
BAND DVD-P
TV/AV
1 2 3
VOLUME
4 5 6
7 8 9
-/--
AUTO SETUP MUTING
0
> 10
=
SKIP
SLOW/SEARCH
u i t y
STOP PAUSE PLAY
g h q
DIRECT NAVIGATOR FUNCTIONS
TOP MENU TUNER
DIRECT TUNING
OK
SUB MENU/
RETURN
PLAY LIST
-EFFECT -LEVEL
C.FOCUS TEST
OFF MUSIC MOVIE
%PL
SFC
Pages
11
6
6
8/17/2007 4:20:12 PM