Display Settings - JVC KW-R910BT Instruction Manual

AUDIO SETTINGS
FADER * 3 * 4
R06 — F06 (00): Adjusts the front and rear speaker
output balance.
BALANCE * 3
L06 — R06 (00): Adjusts the left and right speaker
output balance.
VOL ADJUST –05 — +05 (00): Presets the volume adjustment
level of each source (compared to the FM volume level).
Before adjustment, select the source you want to adjust.
("VOL ADJ FIX" appears if FM is selected.)
AMP GAIN LOW POWER: Limits the maximum volume level to
30. (Select if the maximum power of each speaker is
less than 50 W to prevent damaging the speakers.) ;
HIGH POWER: The maximum volume level is 50.
D.T.EXP ON: Creates realistic sound by compensating the high-
(Digital Track frequency components and restoring the rise-time of
Expander) the waveform that are lost in audio data compression. ;
OFF: Cancels.
L/O MODE SUB.W / REAR: Selects whether rear speakers or a
subwoofer are connected to the REAR/SW line out
terminals on the rear panel (through an external
amplifier).
* 3
This adjustment will not affect the subwoofer output.
* 4
If you are using a two-speaker system, set the fader level
to [00].
16

DISPLAY SETTINGS

1
Press and hold MENU.
2 Turn the volume knob to make a selection (see the following table), then press
the knob.
2
Repeat step until the desired item is selected.
3 Press MENU to exit.
To return to the previous setting item or hierarchy, press G.
DISPLAY
DIMMER Selects the display and button illumination adjusted in the [BRIGHTNESS] setting.
AUTO: Changes between the day and night adjustments when you turn off or on the car
1
headlights. * ; ON: Selects the night adjustments. ; OFF: Selects the day adjustments.
BRIGHTNESS Sets the button, display and USB input terminal brightness for day and night separately.
1 DAY / NIGHT: Select day or night.
2 Select a zone for setting. ( Illustration above)
3 Set the brightness level (00 to 31).
(Default: DAY: 31 ; NIGHT: 15)
2
SCROLL * ONCE: Scrolls the display information once. ; AUTO: Repeats scrolling at 5-second
intervals. ; OFF: Cancels.
* 1
The illumination control wire connection is required. ( 23)
*
2
Some characters or symbols will not be shown correctly (or will be blanked).
Default: XX