Table of Contents
Advertisement
\Qn
\Tn
\Vn
*
Manufacturer default
Extended "AT%" (Percent) Command Set
Command
%B
%Cn
*
Manufacturer default
Extended "AT-" (Dash) Command Set
Command
-Cn
-V90=<n>
to connect in V.42 mode. If this fails, the
call will be disconnected.
Local flow control options
\Q0
Disable flow control (same as "AT&K0")
\Q1
XON/XOFF software flow control (same
as "AT&K4")
\Q3 *
RTS/CTS hardware flow control (same as
"AT&K3")
Set inactive timer (for buffer mode only)
n=0 *
Disable inactive timer
n=1 - 255
Enable inactive timer. Length in minutes
Protocol result codes
\V0
Disable protocol result code appended to
DCE speed
\V1 *
Enable protocol result code appended to
DCE speed
Options
Function & Description
View numbers in blacklist. If blacklisting
is in effect, this command displays the
numbers for which the last call attempted
in the past two hours failed. The ERROR
result code appears in the countries that do
not require blacklisting.
Data compression control
%C0
No data compression
%C1 *
V.42bis/MNP 5 data compression enabled.
Options
Function & Description
Data calling tone options
-C0 *
Disable data calling tone
-C1
Enable data calling tone (the freq. is
1,300 Hz with a cadence of 0.5 sec. ON
and 2 sec. OFF)
command to enable/disable .90 and change
downstream rate
-V90=0
disable V.90
-V90=1
enable V.90 Auto Rate (default value)
-V90=X
controls the downstream rate
-V90?
Shows the current value
- 33 -
Advertisement
Table of Contents
