Abocom ISM560 User Manual page 35

&F
&Gn
&Kn
&Pn
&Qn
&Sn
&Tn
&D0 DTR ignored
&D1 Go to command mode on on-to-off DTR
transition
&D2 * Hang up and go to command mode on on-
to-off DTR transition. Auto-answer is
disabled if DTR is low
&D3 Hang up and reset from user profile 0 on
the on-to-off DTR transition
Recall factory default setting as active
configuration
V.22bis guard tone option
&G0 * No guard tone
&G1 550 Hz guard tone
&G2 1800 Hz guard tone
Set local flow control
&K0 Disable flow control
&K3 * Enable
control (CTS/RTS)
&K4 Enable bi-directional software flow control
(XON/XOFF)
Pulse dialing make/break ratio selection
&P0 Make=39%,
version (Default)
Make=33%, Break=67% for use in 20 pps,
Japanese version
&P1 Make=33%,
version
Make=33%, Break=67% for use in 10 pps,
Japanese version (Default)
Async communications mode options
&Q0 Async mode, buffered (same as "AT\N0")
&Q5 * Error control mode, buffered (same as
"AT\N3")
&Q8 MNP error control mode. If an MNP error
control protocol is not established, the
modem will fallback according to the
current setting in S36 register.
&Q9 V.42 or MNP error control mode. If neither
error control protocol is established, the
modem will fallback according to the
current setting in S36 register.
Data Set Ready (DSR) option
&S0 * DSR always on
&S1 DSR on during handshake and on-line, off
in test mode or idle mode
Self-test commands
&T0 Terminate any test in progress
&T1 Local analog loopback test
bi-directional
Break=61%,
Break=67%,
- 31 -
hardware flow
international
international