Table of Contents
Advertisement
Type ATS0=0, then Enter at the command line to
disable the auto-answer mode.
The modem does not auto-answer the phone.
Make sure the software is configured to auto-answer
the phone.
Type ATS0=n then press Enter. The n stands for the
number of rings the modem will answer on.
The software does not control the modem properly or
can not detect the modem.
Make sure the software has been set up correctly.
Check the initialization and dial strings.
Some TSRs (programs that stay in memory after they
are loaded) may conflict with the communications
software.
Restart your computer without loading any TSRs.
The characters on the screen are doubled.
Both the modem and the software have the echo
feature turned on at the same time.
Turn off the software echo feature off.
The remote modem is echoing your typed characters.
Type ATE1 then Enter at the command line. Then turn
off the software echo feature.
No text appears on the screen when in data mode.
The remote modem is not echoing your typed
characters.
Type ATE0 then press Enter at the command line.
Then turn the software echo feature on.
Your software may not be set to use Full Duplex or the
remote modem may not be set to use Full Duplex
either.
C:The remote modem may be waiting for you to type a
command before it will reply with text.
No text appears on the screen when in command mode.
If you can't see the characters you are typing, then
type ATE1 then press Enter.
- 24 -
Advertisement
Table of Contents
