Controls And Features: Beverage Center; Glass Shelves; Loading; Temperature Control - GE PCR06BATSS Owner's Manual And Installation Instructions

Beverage center & wine chiller
Table of Contents

Advertisement

Available languages

Available languages

Controls and Features - Beverage Center

Temperature Control

The operating temperatures of the beverage center
range from the low forties to the mid fifties. This
appliance is not a refrigerator and does not maintain
temperatures like a refrigerator (below 41°F).
Do not install the beverage center where the temperature
will go below 55°F (13°C) or above 90°F (32°C).
As with any refrigeration-type product, there is a slight
temperature variance at different locations within the
cabinet.
The coolest area will be in the lower part of the cabinet.
The cooler area will be in the middle section.
The upper part of the cabinet is the warmest section.
When the temperature is adjusted, allow 24 hours for the
unit to stabilize.

Glass Shelves

Tempered glass shelves in the beverage center unit are
removable for easy cleaning or for storing larger items.
To remove a shelf, open the door completely to avoid
potential damage to the gasket. Lift up on the back of the
shelf slightly. Tilt the shelf to one side at an angle while
pulling forward.
To replace a shelf, open the door completely to avoid
potential damage to the gasket. Tilt the shelf to one side
at an angle and slide toward the back wall, placing one
side onto the shelf support. Place the other side onto
the opposite shelf support. Ensure rear locking tabs are
engaged. When installed properly, the shelf will not slide
forward when gently pulled.
Loading Tips and Suggestions
• The bottom two full extension drawers hold six bottles
each and are loaded with necks facing the rear. Tall
bottles should not be loaded on the bottom drawer
because they may prevent the door from closing.
• Do not allow children to climb, stand or hang on the
beverage center shelves or full extension drawers.
They could seriously injure themselves and possibly
cause damage to the beverage center.
49-60466-3
To set the control, turn
it to the midpoint setting
(approximately 45ºF). Once
the beverage center is loaded,
allow at least 24 hours before
making any adjustments to the
initial setting.
NOTES:
• This unit is designed for storing and cooling
beverages. It is not intended for the storage of
perishable foods.
• The lowest temperatures are found on the lower
shelves/racks and toward the rear of the shelves/racks.
To remove, lift up on the
back of the shelf
Place in slots when replacing
the shelf
Bottom drawer arrangement
Tilt the shelf at an angle
while removing or replacing
5

Advertisement

Table of Contents
loading

Table of Contents