Panasonic SC-HT530 Operating Instructions Manual page 25

SUPER SRND
Enhancing the bass sound
H.BASS
You can enhance low-frequency sound so that heavy bass sound
can be heard clearly, even if the acoustics of your room are not
optimal. The unit automatically selects the most suitable setting
according to the type of playing source.
Press [H.BASS].
[HT840] [HT880] H.BASS indicator lights on the main unit.
LP MONO STCT
L C R
LS RS
S LFE
12
RND
PGM PRG
H.BASS
≥When DVD-Video or DVD-RAM is selected
H. BASS ON (factory preset),------.H. BASS OFF
≥When another source is selected
H. BASS OFF (factory preset),------.H. BASS ON
The setting you make is retained, and recalled every time you play
the same type of source.
TEST
Speaker level adjustments
SHIFT CH SELECT
This is one of the ways to get appropriate surround effects.
Preparation
Press [DVD/CD].
1
While stopped and no on-screen display is shown
Press [SHIFT]i[TEST] to output a test
signal.
L: Front left C: Center
RS: Right surround LS: Left surround
≥There is no output from SW (subwoofer) channel.
2
Press [VOLUME, r] or [s] to set the
volume level normally used for listening.
3
Press [3] (increase) or [4] (decrease) to
adjust the speaker level for each speaker.
C, RS, LS: `6 dB to i6 dB
(L, R: Only the balance is adjustable.)
≥To adjust the balance of the front speakers
While outputting the test signal, press [2, 1].
≥Adjust the speaker level to the same level as the front
speakers.
To stop the test signal
Press [SHIFT]i[TEST] again.
SUBWOOFER
You can adjust the amount of bass. The unit automatically selects
the most suitable setting according to the type of playing source.
Press [SUBWOOFER LEVEL].
≥When DVD-Video or DVD-RAM is selected
SUB W 4 (factory preset)>SUB W 1>SUB W 2>SUB W 3
^---------------------------------------------------------------------------------------}
≥When another source is selected
SUB W 2 (factory preset)>SUB W 3>SUB W 4>SUB W 1
^----------------------------------------------------------------------------------------}
DIGITAL
PL
CD
RDS PS PTY W
DVD
The setting you make is retained, and recalled every time you play
the same type of source.
∫ To adjust speaker level during play
(Effective when playing multi-channel audio or when Dolby Pro
Logic II or Super Surround is on.)
1
Press [CH SELECT] to select the speaker.
R: Front right
2
Press [3] (increase) or [4] (decrease) to adjust the
speaker level for each speaker.
Subwoofer level
LEVEL
DISC TUNED T G S.SRND D.MIX SLP
DTS
MODE
RAM
# # # # #
L C R RS LS SW
^--------------------------------------------------}
SW: Subwoofer
≥You can adjust SW only if the disc includes a subwoofer
channel.
≥"SW" does not appear on the display and is not adjustable
when Dolby Pro Logic II is turned on.
≥"S" appears on the display when "MUSIC" or "MOVIE" is
selected with Super Surround (➜ page 24). In this case, you
can adjust both surround speaker levels at the same time
using [3, 4].
S: `6 dB to i6 dB
C, RS, LS, SW: `6 dB to i6 dB
(L, R: Only the balance is adjustable.)
≥To adjust the balance of the front speakers
While "L" or "R" is selected, press [2, 1].
MONO STCT
L C R
LS RS
S LFE
RND 12
PGM PRG
H.BASS
RQT7978
25