Transporting And Storing The Appliance - Siemens DW03500 pureFlow Instructions For Use Manual

Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 26
To replace the filters, proceed as follows:
Switch off the appliance and unplug it.
Shut off the water supply at the connection
valve (6c).
Unscrew the two screws (5a) on the filter cover
(5) and remove the cover.
Now, swing out the filter carrier (4) by 30° and
pull off the used filter cartridges. To do this, push
the ring upward and pull the filter downward.
Water droplets may form and drip when replacing
the filters.
1
Insert the new filter cartridges until they click
audibly into place. The filters are marked with
a small arrow on the upper edge. This indicates
the front side of the filter when inserting it.
Swing the filter carrier (4) back in place.
Reinstall the cover (5) using the two screws (5a).
When replacing a filter, the filter must be rinsed
twice and the tank is to be wiped clean with a
fresh cleaning cloth. Refer to "Draining the water
tanks".
40
2
3
30°
en
Important:
After every filter replacement, the operating time-
count of the respective filter must be reactivated.
This is also indicated by a blinking light. To set the
operating time-count, please proceed as follows.
After replacing the Neo-Sense Filter (Filter No. 1):
Press and hold the push-button
tion) and selection button
taneously for at least 3 seconds.
The new operating time-count is activated.
After replacing the RO Membrane Filter
(Filter No. 2):
Press and hold the push-button
tion) and selection button
simultaneously for at least 3 seconds.
The new operating time-count is activated.
After replacing the Post-Carbon Block Filter
(Filter No. 3):
Press and hold the push-button
tion) and selection button
taneously for at least 3 seconds.
The new operating time-count is activated.
Transporting and storing the
appliance
If the appliance is to be transported or stored, all
water must be removed from the appliance.
Only transport or store the appliance in an upright
position.
Please look up the procedure in Chapter "Draining
the water tanks" and carry this out completely ex-
cept for the last point (Open the water supply again,
insert the appliance's electrical plug in the electrical
socket and switch the On/Off switch to I).
(Child protec-
(Hot water) simul-
(Child protec-
(Ambient water)
(Child protec-
(Cold water) simul-

Advertisement

Table of Contents
loading

Table of Contents