Draining The Water Tanks - Siemens DW03500 pureFlow Instructions For Use Manual

The appliance now filters tap water for approx.
2 hours and fills the three tanks with purified water.
The tanks are filled when both LED indicators "Hot
water"(17) and "Cold water" (18) light up completely.
LED Hot water
Now completely empty the water from the tanks.
■

Draining the water tanks

Draining the cold water tank and ambient water
tank
Shut off the water supply at the connection
■
valve (6c).
Connect the straight end of the attached drain-
■
age hose (28) to the drink water outlet (24). Lay
the other end in a large, clean collecting basin
(min. 2 litres).
en
LED Cold water
Important
The drainage hose (28) should slope down toward
the water collecting basin. Otherwise, the flow
throughput will be reduced and complete water
drainage will be impeded.
Press and hold the selection button
■
ter) for approx. 3 seconds to switch off the cold
water function.
Press and hold the dispensing button
■
3 seconds.
Water runs out of the drainage hose for 1 minute.
Repeat the procedure until no more water flows
■
out.
Draining the hot water tank
Switch off the Water Purifier and pull out the
■
electrical plug.
27b
27a 27
Gently press the sliding door (27) inward and
■
slide the handle downward.
Flip the red safety lock cap (27a) outward.
■
Lay the straight end of the attached drainage
■
hose (28) in a large, clean collecting basin (min.
2 litres).
Important
The drainage hose should slope down toward the
water collecting basin. Otherwise, complete water
drainage will be impeded.
(Cold wa-
for
28
33