Inserting Media; Charging Ipod/Iphone/Ipad - Panasonic SC-HC18 Operating Instructions Manual

Inserting media

[SC-HC28]
Select "IPOD_PORT" as the source
"USB" is displayed when a compatible USB is inserted.
[SC-HC18]
Select "USB" as the source
*4
iPod RADIO
/USB
[SC-HC28] Attach the pad before using this unit. (l 15)
[SC-HC28]
Select "IPOD_DOCK" as the source
Connect using the Lightning connector *1
*1: Refer to "Playable media" for compatible models. (l 12)
– Do not connect an iPad (4th generation) to the
"IPOD_DOCK" connection. This unit might fall over.
Use the "IPOD_PORT" connection.
*2: When using the "IPOD_PORT" connection, do not connect
the following models to this unit:
– iPod classic, iPod [4th (colour display), and 5th (video)
generation]
Unexpected behaviour may occur.
*3: Connect using the dedicated USB cable (not supplied).
*4: Insert the USB device directly. Do not use any USB
extension cable.
*5: When using the "IPOD_DOCK" connection:
≥ Be sure to remove the iPod/iPhone/iPad mini from its case.
≥ Make sure that the iPod/iPhone/iPad mini is fully inserted.
≥ If the iPod/iPhone/iPad mini is pushed to the left or right,
make sure to check that it is still fully inserted.
≥ Make sure to hold the dock when removing the iPod/
iPhone/iPad mini.
≥ Make sure to close the dock properly after using it.
If not,
– The sliding door will not open.
– The standby power consumption will increase.
*6: Make sure to tilt the disc so as not to touch the sliding door.
6
RQT9734
[SC-HC28]
*1, 2, 3
iPad
VOLUME OPEN/CLOSE
*5
Select "CD" as the source
≥ Do not open the sliding door manually.
≥ Make sure that the unit does not fall when inserting or
removing media.
≥ When moving this unit, be sure to remove all media and turn
this unit to standby mode.
≥ Before removing the USB device, select a source other than
"USB".
[SC-HC28]
Charging an iPod/iPhone/iPad
Charging starts when an iPod*
connected to this unit.
≥ During standby mode, charging will not start from the
"IPOD_PORT" connection, however it will start as usual from
the "IPOD_DOCK" connection.
– To charge from the "IPOD_PORT" connection, start the
charging before turning this unit to standby mode.
≥ Check the iPod/iPhone/iPad to see if the battery is fully
charged. (Once fully recharged, additional recharging will not
occur.)
≥ If this unit is switched to standby mode
"IPOD CHARGING" is shown on the unit's display.
*6
OPEN/CLOSE
pad
(supplied)
PUSH
/iPhone/iPad is
2