Stihl FS 94 Instruction Manual page 17

4
3
5
6
7
Place the clamp (3) in the loop
N
handle (4) and position them both
against the drive tube (5).
Position the clamp (6) against the
N
drive tube.
Place the barrier bar (2) in position
N
as shown.
Line up the holes.
N
Insert the screws (7) in the holes
N
and screw them into the barrier
bar (2) as far as stop.
Go to "Securing the Loop Handle".
N
FS 94, FS 94 R, FS 94 C, FS 94 RC
Mounting the Loop Handle without
Barrier Bar
2
Place the clamp (3) in the loop
N
handle (4) and position them both
against the drive tube (5).
Position the clamp (6) against the
N
drive tube.
Line up the holes.
N
Fit washers (8) on the screws (7)
N
and insert the screws in the holes.
Fit the square nuts (1) and screw
them down as far as stop.
Go to "Securing the Loop Handle".
N
7
7
8
8
4
3
5
6
1
1
Adjusting and Securing the Loop Handle
A
4
The loop handle can be adjusted to suit
the height and reach of the operator and
the application by changing
distance (A).
Recommendation: distance (A):
about 30 cm (12 in)
Slide the handle to the required
N
position.
Line up the loop handle (4).
N
Tighten down the screws until the
N
loop handle can no longer be
rotated on the drive tube. If no
barrier bar is fitted – lock the nuts if
necessary.
English
15