Stihl FS 94 Instruction Manual page 15

1
7
6
4
A
3
Mount the handlebar (1) on the
N
drive tube (2) about 40 cm (15 in)
(A) forward of the engine housing.
Place the clamp (3) and handle
N
support (4) against the drive
tube (2).
FS 94, FS 94 R, FS 94 C, FS 94 RC
5
5
2
Place the handlebar (1) in the
N
handle support so that distance B is
no more than 15 cm (6 in) – the
rubber handle (5) must be on the left
(viewed from engine).
Place the clamp (6) on the handle
N
support.
Insert the screws (7) through the
N
holes in the parts and screw them
into the clamp (3) as far as stop.
Line up the handlebar.
N
Tighten down the screws firmly.
N
B
1
Mounting the Control Handle
4
3
1
2
Take out the screw (1) – the nut (2)
N
remains in the control handle (3).
Push the control handle onto the
N
handlebar (5) until the holes (6) line
up – the throttle trigger (4) must
point towards the gearbox.
Insert the screw (1) and tighten it
N
down firmly.
Fitting the Throttle Cable
NOTICE
Do not kink the throttle cable or lay it in
tight radii – make sure the throttle trigger
moves freely.
English
6
5
6
13