Fitting The Full Harness - Stihl FS 310 Instruction Manual

Refueling
Take care not to spill fuel while fueling
and do not overfill the tank. STIHL
recommends use of the STIHL filling
system (special accessory).
Closing the cliplock filler cap
Position the cap with the clip in an
N
upright position; the markings must
line up
Turn cap clockwise as far as it will
N
go (approx. 1/4 turn)
Fold the cliplock down so that it is
N
flush with the surface
If the cliplock is not flush with the surface
and the lug on the clip does not engage
entirely in the recess (arrow), the cap is
not properly closed and the steps
described above must be repeated.
FS 310
Opening screw-type tank cap
Turn the cap counterclockwise until
N
it can be removed from the tank
opening.
Remove the cap.
N
Filling up with fuel
Take care not to spill fuel while fueling
and do not overfill the tank. STIHL
recommends you use the STIHL filler
nozzle (special accessory).
Closing screw-type tank cap
Place the cap in the opening.
N
Turn the cap clockwise as far as
N
stop and tighten it down as firmly as
possible by hand.

Fitting the Full Harness

2
3
Put on the full harness (1).
N
Adjust the length of the strap so that
N
the spring hook (2) is about a hand's
width below your right hip. Over-
long ends of straps may be
shortened after completing the
adjustment.
Attach the spring hook to the
N
machine's perforated strip (3).
Find the right attachment point for the
cutting attachment you are using – see
"Balancing the Brushcutter".
English
1
23