Adjusting The Throttle Cable - Stihl FS 310 Instruction Manual

English
A
4
1
Place the handlebar (4) in the lower
N
clamp (1) so that distance A is no
more than 15 cm.
Place the upper clamp in position
N
and press it down.
Insert the clamping screw.
N
Line up the handlebar at a right
N
angle to the drive tube.
Tighten down the clamping screw
N
firmly.
14
8
7
5
6
Take out the screw (5), the nut (6)
N
remains in the control handle (7).
Push the control handle onto the
N
end of the handlebar (4) until the
holes (9) line up – the throttle
trigger (8) must point towards the
gearbox.
Insert the screw and tighten it down
N
firmly.
Go to "Adjusting the Throttle Cable".
N
Transport and storage position: Loosen
the clamping screw, turn the handlebar
in line with the drive tube and fold the
handles down.

Adjusting the Throttle Cable

A properly adjusted throttle cable is the
precondition for correct operation in the
full throttle, starting throttle and idle
7
positions.
Adjust the throttle cable only after the
unit is fully assembled – the control
9
handle must be in the normal operating
position.
4
9
Use a suitable tool to push the slide
N
to the end of the slot (see
illustration).
Press down the throttle trigger
N
lockout (1) and squeeze the throttle
trigger (2) (full throttle) – this sets
the throttle cable correctly.
2
1
FS 310